Kenmore Sears 16642 Owner's Manual page 4

IMPORTANT SAFETY
INSTRUCTIONS
Your sewing machine is designed and constructed only for HOUSEHOLD use.
Read all instruction before using this sewing machine.
DA NG E R -To reduce the risk o felectric shock:
!. An appliance should never be left unattended when plugged in. Always
unplug this appliance from the electric outlet immediately after using
and before cleaning,
2. Always unplug before relamping. Replace bulb with same type rated
15 Watts.
3. Do not reach for the appliance that has fallen into water. Unplug
immediately
4. Do not place or store appliance where it can tall or be pulled into a tub
or sink. Do not place in or drop into water or other liquid.
WA RN ING
--To reduce the risk of burns, fire, electric shock,
or injury to persons.
1. Do not atlow to be used as a toy. Close attention is necessary when this
appliance is used by or near children.
2. Use this appliance only for its intended use as described Jn this manual.
Use only attachments recommended by the manufacturer as contained in
this manual.
3.
Never operate this appliance if it has a damaged cord or plug, if it is not
working properly, if it has been dropped or damaged, or dropped into
water. Return the appliance to the nearest authorized dealer or service
center for examination, repair, electrical or mechanical adjustment.
4. Never operate the appliance with any air opening blocked. Keep
ventilation openings oi the sewing machine and loot controller tree from
accumulation of lint, dust, and loose cloth.
5. Never drop or insert any object into any opening.
6. Do not use outdoors,
7. Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
8. To disconnect, turn all controls to the off (-O") position, then remove
plug from outlet.
9. Do not unplug by pulling on cord. To unplug, grasp the plug, not the
cord.
10.
11.
Keep fingers away from all moving parts. Special care ts required
around the sewing machine need]e_
Always use the proper needle plate, The wrong plate can cause the
needle to break.
12. Do not use bent needles.
13.
14.
Do not pull or push labric while stitching.
It may deflect the needle causing it to break.
Switch the sewing machine off (*'O °') when making any adiustment in
the needle area, such as threading needle, changing needle, threading
bobbin, or changing presser loot, and the like.
15. Always unplug the sewing machine from the electrical outlet when
removing covers, lubricating, or when making any other adjustments
mentioned in the instruction manual.
SAVE THESE INSTRUCTIONS