For personal safety, the cooktop must be properly grounded. For
maximum safety, the power cord must be plugged into an electrical
outlet that is correctly polarized and properly grounded.
DO NOT Operate the cooktop using a 2-prong adapter or an
extension cord. If a 2-prong watt receptacle is the only available
outlet, it is the personal responsibility of the consumer to have it
replaced with a properly grounded 3-prong wall receptacle installed
by a qualified electrician.
See the INSTALLATION
packaged with this
cooktop for complete installation and grounding instructions.
appliance is equipped with a 3-prong grounding
plug for your protection against shock hazard and should be plugged
directly into a properly grounded receptacle. DO NOT cut or remove
the grounding prong from this plug.
remove, or bypass
the grounding prong.
Power supply cord with
3-prong grounding plug
Avoid fire hazard or electrical
shock. DO NOT use an adapter plug, an extension
cord, or remove grounding prong from electrical
power cord. Failure to follow this warning can
cause serious injury, fire or death.
Liquefied Petroleum (Propane) Gas Conversion
This appliance can be used with Natural Gas and Propane Gas. It is
shipped from the factory for use with natural gas.
A kit for converting to LP gas is supplied with your cooktop. The kit
is marked "FOR LP/PROPANE
The conversion must be performed by a qualified service technician
in accordance with the kit instructions and all local codes and
requirements. Failure to follow instructions could result in serious
injury or property damage. The qualified agency performing this work
assumes responsibility for the conversion.
Severe shock, or damage to the
cooktop may occur if the cooktop is not installed
by a qualified installer or electrician.
Any additions, changes or
conversions required in order for this appliance to
satisfactorily meet the application needs must be
made by an authorized Sears Service Center, LP
Distributor or other Qualified Agency.
Using cookwares larger than 9" wide on front
burners could expose you to burn hazard ( by
unintentional contact with pan) when turning
ON/OFF the burner valves.
For best practical considerations, please
follow the Recommended Pan Configuration.