Replacing The Light Bulb - Kenmore 214.34000 Owner's Manual

3.Remove and dispose ofused filter.
4.Replace with new filter ( 3M Filtrete
TM
Style 6).
5. Replace Filter Frame by sliding it back
into place, making sure the two tabs at
the top of the frame are tucked under and
that the hole at the bottom of the frame is
centered over the screw hole.
6. Replace and tighten screw.
Replacing the Light Bulb
1. Unplug vacuum. Press gently with your
foot on the Power Foot and lean the unit
back so that the Headlight is revealed.
2. Insert the tip of a blade-type screwdriver
at either of the connector tabs at the
bottom of the headlight lens. Pry gently to
remove the lens.
Checking the Rotating Brush and
Drive Belt
The brush and drive belt should both be
checked regularly for wear or damage. The
brush and brush ends should also be kept
free of string, hair, and carpet fibers as
these could become entangled in the brush
and reduce its cleaning effectiveness.
Cleaning the Rotating Agitation Brush
Note:TheRotating Brush canmostoftenbe
cleaned without r emoving itfrom thevacuum. I f
thereisanexcessive a mount o f hairanddebris,
however, it should heremoved andcleaned.
1. Unplug the vacuum. Tip it over, face
down, on a flat surface.
2. Using a Phillips head screwdriver,
remove all 3 screws from the bottom of
the Power Foot.
3. Remove used bulb from socket.
4. Insert new bulb (Part #010-1177). It
should snap into place.
5. Reinstall lens, inserting the top section
first and snapping the bottom section into
place.
3. Holding onto both the top cover and
base, turn the vacuum back over. Lift off
the top cover and the Furniture
Protection Guard.
t t
-'; t. ]2 ]-_TJ
4. Slide the Drive Belt off the motor shaft.
(You can also check the Drive Belt for
wear or damage at this time and replace
as necessary.)