2 center control cover
3 computer base
3. Remove the center control cover:
a. Open the display all the way (180 degrees) so that it lies flat against your work surface.
b. Starting on the right side of the computer, use a plastic scribe to pry up the center control cover. Lift it away from the computer, and lay it aside.
center control cover
4. Remove the keyboard:
a. Remove the two M2.5 x 6-mm screws across the top of the keyboard.
The keycaps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Be careful when removing and handling the
Lift the keyboard carefully in
b. Rotate the keyboard up 90-degrees and slide it forward to gain access to the keyboard connector.
c. Pull up on the keyboard connector tab to disconnect the keyboard connector from the system board.
When you replace the keyboard, ensure that the keyboard tabs are completely in place to avoid scratching the palm rest.
to ensure that you do not pull on the keyboard wire.