Connecting To A Wireless Local Area Network; Determining The Wireless Network Device Manager - Dell D610 - Latitude Centrino Laptop 1.6ghz 512mb 40gb Wifi Xp Pro 14" Lcd User Manual

User guide

page of 116

/ 116
Contents
Table of Contents
Bookmarks

Table of Contents

1. Contact your Internet service provider (ISP) to obtain specific information about the connection requirements for your broadband modem.

2. Ensure that you have wired Internet access through your broadband modem before you attempt to set up a wireless Internet connection.

3. Install any software required for your wireless router. Your wireless router may have been shipped with an installation CD. Installation CDs usually

contain installation and troubleshooting information. Install the required software according to the instructions provided by the router manufacturer.

4. Shut down your computer and any other wireless-enabled computers in the vicinity through the Start menu.

5. Disconnect your broadband modem power cable from the electrical outlet.

6. Disconnect the network cable from the computer and the modem.

NOTE:

Wait for a minimum of 5 minutes after disconnecting your broadband modem before you continue with the network setup.

7. Disconnect the AC adapter cable from your wireless router to ensure that there is no power connected to the router.

8. Insert a network cable into the network (RJ-45) connector on the unpowered broadband modem.

9. Connect the other end of the network cable into the Internet network (RJ-45) connector on the unpowered wireless router.

10. Ensure that no network or USB cables, other than the network cable connecting the modem and the wireless router, are connected to the broadband

modem.

NOTE:

Restart your wireless equipment in the order described below to prevent a potential connection failure.

11. Turn on only your broadband modem and wait for at least 2 minutes for the broadband modem to stabilize. After 2 minutes, proceed to

12. Turn on your wireless router and wait for at least 2 minutes for the wireless router to stabilize. After 2 minutes, proceed to the

13. Start your computer and wait until the boot process completes.

14. See the documentation that came with your wireless router to do the following in order to set up the wireless router:

Establish communication between your computer and your wireless router.

Configure your wireless router to communicate with your broadband router.

Find out your wireless router's broadcast name. The technical term for the name of your router's broadcast name is Service Set Identifier (SSID)

or network name.

15. If necessary, configure your wireless network card to connect to the wireless network. See

Connecting to a Wireless Local Area Network

NOTE:

Before you connect to a WLAN, ensure that you have followed the instructions in

NOTE:

The following networking instructions do not apply to internal cards with Bluetooth

This section provides general procedures for connecting to a network via wireless technology. Specific network names and configuration details vary. See

Setting Up a New WLAN

for more information about how to prepare for connecting your computer to a WLAN.

Your wireless network card requires specific software and drivers for connecting to a network. The software is already installed.

NOTE:

If the software is removed or corrupted, follow the instructions in the user documentation for your wireless network card. Verify the type of

wireless network card installed in your computer and then search for that name on the Dell Support website at support.dell.com. For information on the

type of wireless network card that is installed in your computer, see