Craftsman 486.24321 Operator's Manual page 6

step 7:
(see FIGUre 7)
• Assemble the flow control link (end with small hole) to
the flow control arm using a 1/4" x 1" hex bolt, a nylon
washer and a 1/4" nylock nut. tighten carefully. The
flow control link should not be loose but should pivot
with no more than slight resistance.
FLOW CONTROL
LINK
1/4" x 1"
HEX BOLT
SMALLEST
HOLE
NYLON
WASHER
FIGUre 7
step 8:
(see FIGUre 8)
• Assemble the flow control arm to the flow control
mounting bracket using a 1/4" x 1" hex bolt, two nylon
washers and a 1/4" nylock nut. tighten carefully.
The flow control arm should be snug, but should pivot
with no more than a slight resistance.
• Assemble the vinyl grip.
VINYL GRIP
FLOW
CONTROL
ARM
1/4" x 1"
HEX BOLT
(2) NYLON
WASHERS
FIGUre 8
6
FLOW
CONTROL
ARM
1/4" NYLOCK
NUT
FLOW CONTROL
MOUNTING
BRACKET
1/4" NYLOCK
NUT
step 9:
(see FIGUre 9)
• Place a 5/16" flat washer onto the end of the flow
control rod. Insert the end of the rod through the slot
in the flow control mounting bracket and through the
hole in the flow control link. Secure with a 3/32" x 3/4"
cotter pin.
5/16" FLAT
WASHER
FLOW
CONTROL
ROD
FIGUre 9
step 10:
(see FIGUre 10)
• Hook free end of flow control rod through hole in slide
gate bracket located near the bottom of the hopper.
FIGUre 10
Call 1-866-576-8388 for missing parts or assembly help
3/32"
COTTER
PIN
SLOT
FLOW
CONTROL
LINK
DO NOT RETURN TO STORE