Table of Contents
Advertisement
Design Information
MODELS AVAILABLE
ZDIC!50, ZDIS!50
The icemaker
nag be installed below a countertop
Available in black, white and stainless steel,
or used free-standing,
CUTOUT & PRODUCT DIMENSIONS
"16-1/2" with a 3/4" thick
custom panel
_'n I
J" The installation of a 3/4" thick
'-t._\k/
custom panel will require an
L
addtona
1-1/2"wdef
er
strip on the hinge side.
34" rain.
Adjustable
to 34-1/2"
23-5/16" to
Cutout dimensions
shown allow for a full door swing.
Additional
Clearances:
• The installation
of a 3//4" thick custom panel will
require an additional
1-1/2" wide filler strip on the
hinge side. The filler strip will act as a spacer
between the icemaker
case and an adjacent
cabinet. The filler strip will prevent interference
with the icemaker door swing when it is installed
between frameless or framed cabinetrg.
The width
of the opening must
include the filler strip.
NOTE: The addition
of
a 3/4" thick front panel
will result in a front to
back depth of 24-1/16."
The product cannot be
installed flush to
adjacent
24" deep
cabinets with a
3/4" thick custom panel.
I
Factorg set
",
\ -
for 110°door
",,,
swing, Allow 2"
',,
rain to wall for
1102
",_ "_,
90° door swing
_t
i
5-1/2" Minimum
to Wall
OPTIONAL ACCESSORIES
ZIP75WW White and ZIP75BB Black--For
the
installation
of a trimless 3/4" thick custom panel
on white and black models (not for stainless steel
models). This kit provides a handle that can be
installed with the custom panel. A custom handle
of gour choice may be installed onto the 3/4" panel.
See installation
instructions
on pages 9 and !0.
ZTBSSl--Monogram
tubular
stainless
steel handle
for 3/4" thick custom
panels. Order this kit from gour
Monogram
supplier,
ZPK1--Drain
Pump Kit. For use when a floor drain is
not available. The drain pump must be installed inside
the unit and can operate at a maximum
vertical
height of !0 feet. !0 feet of tubing is supplied with
the kit.
TOOLS AND MATERIALS REQUIRED
• 1//4" socket
• 3//4" adjustable
wrench
• Level
GE SmartConnecf"
Refrigerator Tubing Kit or 1/4" O.D.
copper tubing, of sufficient length to reach the installation
Advertisement
Table of Contents
