Table of Contents
Advertisement
1. Locate the gas regulator (1-1). Grasp the regulator (1-1)
with the knob (1-2) facing directly up. Line up the collar on
the regulator (1-1) with the open end of the burner tube (1-
3) as shown in fig. 1.
Fig. 1
Fig, 2
2. Screw the regulator (2-1) into the open end of burner (2-2)
as shown in fig. 2.
3. Once the regulator is in as far as it will go, tighten with a
wrench. Turn the regulator so that the knob is facing
forward. Note: Always make sure the regulator is secured
facing forward in the fully lock-in position before attaching
propane cylinder.
Fig, 3
4. (3-2)Be sure the gas control knob (3-1)is in the "OFF"
position. Check to make sure threaded areas on cylinder
and regulator are clean. Screw the propane cylinder (3-2)
onto the regulator (3-3) making sure to engage threads
correctly to achieve proper connection. To remove the
propane cylinder (3-2) unthread the cylinder from the
regulator (3-3) as shown in fig.3.
7
Advertisement
Table of Contents
