Sliding Buttonhole Foot - Kenmore Sears 385.12216 Owner's Manual

SECTION VII. BUTTONHOLE
Buttonhole
0_ Stitch selector:
(_) Stitch length:
(_ Top thread tension:
(_ Presser foot:
Blue zone
1 to5
Sliding buttonhole foot
O
TYPE
®
Depending on your preference, you may adjust stitch
density within the blue zone on the stitch length
control°
" For more density, turn the stitch length control
toward "0"_
(_ Fine stitches for lightweight fabrics..
'_' For less density, turn the stitch length control
toward "1 'L
(_ Coarse stitches for heavyweight fabrics..
NOTE: Always check a buttonhole on a scrap of
fabric to make sure the adjustment satisfies
you_
• To Sew
Carefully mark buttonhole length on fabric,
Place the fabric under the foot with the buttonhole
marking running toward you°
Move the slider (A) toward you so that the top mark
(C) on the slider meets the start mark (B), Line up
the markings on the foot with the top mark on the
fabric,. Lower the presser foot.
NOTE: The markings on the slider are engraved in
centimeters..
r_
Set the stitch selector at _ Sew forward until you
reach the front marking of your buttonhole, Stop
sewing at a left stitch.
®
0
"-,....
58