Oven Door - Kenmore 665.92002 Use And Care Manual

--or normal range use, it is not suggested to remove the oven
door. However if necessary, follow these instructions. The oven
door is heavy
To Replace:
1. GrasD the door on the sides with your fingers on the front of
the door and your thumbs on its inside surface
2. HOld oven door so that the top edge of each hinge hanger is
horizontal. Insert hinge hangers into the front frame hinge
SlOtS,
Before Removing:
1. Use a DuEy Knife or screwdriver and insert it at the bottom
corner of the door stop clip,
3.
Tilt too of door toward range, Slide hinge hangers down onto
front frame support p_ns. Make sure the hinge hangers are
full:y seated and engagea on the support plns,
1
2
3
!. Door Stop Clip
2. Pry door stop clip free and remove from front frame hinge
slot, Take care no[ to scratch finish,
3. Repeat procedure for other door stop clip,
4.
To Remove:
I. Open the oven door, Insert door removal Dins ncluded with
your range into both hinge hangers. Do not remove the Dins
while the door is removed from the range
\
\
I
\
2
\
1. Hinge hanger
Z Door frame hinge
3. Support pins
Insert the door stop ClIDwith its angular surface at the top of
the frame hinge slot then push in the bottom of the clip until
its flanges are flush with the front frame
5. ODen the door completely and remove the cioor removal 3ins.
Save door removal pins for future use.
6. Close the door
1. Removal pins
2. Hinge hanger
2. Carefully close the door until it rests against the door removal
DInS
3. Graso the door on the s_des w_th your fingers on the front of
the door and your thumbs on the inside surface,
4. Pull door straight up then towarc you, Hinge hangers w_ll
Sto[sc _=D_awe_
The storage drawer can be removed. Before removing, make sure
drawer is cool and emD[y.
To Remove:
1. Pull drawer straight out to the first stop,
2. Lift up the back of the drawer and pull out
slide out of front frame hinge slot. Do not remove aoor
removal Dins until the door is re31aced on the range. To Replace:
I. Fit the ends of the drawer rails into the guides in the cavity
2. Slide the drawer closec
24