Optimum Operation - Daikin FTQ18PBVJU Operation Manual

2
On/Off
nu
K
• Press On/Off button.
The Operation lamp (green)
will illuminate and the sys-
tem will start operating.
* In Dry mode, the system maintains automatic
temperature and fan speed control. Therefore,
temperature setpoint or fan speed settings are
not available while the indoor unit is in the Dry
mode.
• Adjust Air Flow Direction from the main
3
menu.
* If the connected indoor unit model does not
include oscillating louvers this function will not
be available.
4
On/Off
nu
K
• When the On/Off button is
pressed again, the system
will stop operating and the
operation lamp will turn off.
NOTE
• To prevent water damage or system failure, do
not immediately remove power from the indoor
unit following system operation. Wait at least fi ve
minutes for the condensate pump to fi nishing
draining residual water from the unit.
CHARACTERISTIC OF DRY MODE
• The Dry mode dehu-
midifys the space at
reduced cooling capac-
ity to prevent the room
temperature from drop-
ping to uncomfortable
levels.
9
Refer to fi gure 3 on page [1]
1. Operation mode
2. Fan Speed
3. Setpoint display
4. Stand by for Defrost/Hot start
5. Message
6. ( ) display
7. ( ) display
8. Under centralized control
9. Changeover controlled by the master in-
door unit
10. Setback
Please refer to attached manual with remote con-
troller for another operation.
7.

OPTIMUM OPERATION

Observe the following precautions to ensure the
system operates.
• Adjust the room temperature properly for a com-
fortable environment. Avoid excessive heating or
cooling.
• Prevent direct sunlight from entering a room
during cooling operation by using curtains or
blinds.
• Ventilate the room regularly.
Using the unit for long periods of time requires
attentive ventilation of the room.
• Keep doors and windows closed. If the doors
and windows remain open, air will escape and
diminish cooling or heating operation.
• Never place objects near the air inlet and the air
outlet of the unit. It may cause deterioration in
the effect or stop in the operation.
• Turn off the main power supply switch when it is
not used for long periods of time. When the main
power switch is turned on, some watts of elec-
tricity is being used even if the system is not
operating. Turn off the main power supply switch
for saving energy. When reoperating, turn on the
main power supply switch 6 hours before opera-
tion for smooth running (Refer to MAINTE-
NANCE).
• When the display shows "Time to clean fi lter",
ask a qualifi ed service person to clean the fi lters
(Refer to MAINTENANCE).
English