Using Additional Map Data; Changing The Zoom Range - Garmin eTrex HC series Owner's Manual

Position mode pans the map to keep your present
location in the display area. The position marker
shows your travel on the Map page.
When you press the ROCKER, the eTrex enters pan
mode, which moves the map to keep the white arrow
(map pointer) within the display area. Add and
configure up to four optional data fields at the top of
the page to provide a varity of travel and navigational
information.
To show data fields on the Map Page:
1. Press MENU > Data
menu appears.
2. Select the number of data fields you want to
show on the Map page, and press ENTER.
To change a data field display:
1. Press MENU > Change Data Fields. The first
data field is highlighted.
2. Press ENTER.
3. Select an option.
4. Move to the next field, and repeat.
eTrex HC series Owner's Manual
Fields. The Show sub-

Using Additional Map Data

View listings of nearby restaurants, lodging, shopping
centers, attractions and entertainment, and retrieve
addresses and phone numbers for any listed location
when using optional MapSource data disks and pre-
programmed microSD cards.
To review map information:
1. From the Map page, press MENU > Setup
.
Map
2. Select the Map Setup-information page. The
list of maps stored appears. A check mark
means the map is shown on the Map page.

Changing the Zoom Range

Press the In key to decrease the zoom range and
show an area with greater detail; press the Out key to
increase the range to see a larger area with less detail.
The current zoom range setting is shown in the
lower-left corner of the Map page. If no further map
information is available, "overzoom" appears under
the zoom range. When using MapSource maps,
"mapsource" appears below the scale.
M p
aIn aGeS
5