Adding Phones With Auto-Registration And Taps - Cisco Unified 7975G Preparing To Install

Adding Phones to the Cisco Unified Communications Manager Database
Cisco recommends you use auto-registration to add less than 100 phones to your network. To add more
Note
than 100 phones to your network, use the Bulk Administration Tool (BAT). See
BAT, page
Auto-registration is disabled by default. In some cases, you may not want to use auto-registration; for
example, if you want to assign a specific directory number to the phone or if you plan to use secure
connection with Cisco Unified Communications Manager as described in Cisco Unified
Communications Manager Security Guide. For information about enabling auto-registration, refer to
Enabling Auto-Registration in the Cisco Unified Communications Manager Administration Guide.
When you configure the cluster for mixed mode through the Cisco CTL client, auto-registration is
Note
automatically disabled. When you configure the cluster for nonsecure mode through the Cisco CTL
client, auto-registration is not automatically enabled.
Related Topics
•
•
•

Adding Phones with Auto-Registration and TAPS

You can add phones with auto-registration and TAPS, the Tool for Auto-Registered Phones Support,
without first gathering MAC addresses from phones.
TAPS works with the Bulk Administration Tool (BAT) to update a batch of phones that were already
added to the Cisco Unified Communications Manager database with dummy MAC addresses. Use TAPS
to update MAC addresses and download pre-defined configurations for phones.
Cisco recommends you use auto-registration and TAPS to add less than 100 phones to your network. To
Note
add more than 100 phones to your network, use the Bulk Administration Tool (BAT). See
with BAT, page
To implement TAPS, you or the end-user dial a TAPS directory number and follow voice prompts. When
the process is complete, the phone will have downloaded its directory number and other settings, and the
phone will be updated in Cisco Unified Communications Manager Administration with the correct MAC
address.
Auto-registration must be enabled in Cisco Unified Communications Manager Administration
(System > Cisco Unified CM) for TAPS to function.
When you configure the cluster for mixed mode through the Cisco CTL client, auto-registration is
Note
automatically disabled. When you configure the cluster for nonsecure mode through the Cisco CTL
client, auto-registration is not automatically enabled.
Refer to Cisco Unified Communications Manager Bulk Administration Guide for detailed instructions
about
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.5
2-12
2-13.
Adding Phones with Auto-Registration and TAPS, page 2-12
Adding Phones with Cisco Unified Communications Manager Administration, page 2-13
Adding Phones with BAT, page 2-13
2-13.
BAT and about TAPS.
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Adding Phones with
Adding Phones
OL-23092-01