Soil Settler Soil Removal System; Start-Up Guide; Using Your New Dishwasher; Connecting The Dishwasher - Kenmore 665.1766 Series Use And Care Manual

The Soil Settler soil removal system cleans by spraying a mixture
of hot, clean water and detergent against soiled dishes.
To clean the Soil Settler filter screen
1. Wait at least 20 minutes after a cycle for the heating element
to cool down.
2. Unload and slide the bottom rack forward. (Remove bottom
rack if necessary to reach filter screen.)
3. Remove collected particles from the screen with your finger
or a paper towel.
3=
4.
Rinse aid is essential for good drying. Be sure to fill the
dispenser before you use your new dishwasher. Each filling
will last about 1 to 3 months depending on your usage.
Scrape large food soil and hard items (toothpicks or bones)
from dishes.
Properly load the dishwasher. (See "Dishwasher Loading.")
Load dishes with space in between so water will reach the
soiled surfaces. Make sure nothing prevents the spray arm(s)
from spinning freely.
4. Return the bottom rack to its original position.
START-UP GUIDE
Before using your dishwasher, remove all packaging materials.
Read this entire Use and Care Guide. You will find important
safety information and useful operating tips.
Etectrica_ Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
A power supply of 120 volts, 60 Hz AC, 15 or 20 amps, is
required.
1. Plug into a grounded 3 prong outlet.
5=
6.
Add detergent. Always use a quality brand detergent. (See
"Dishwasher Use.")
Push door firmly closed. The door latches automatically. Run
hot water at the sink where you will connect dishwasher until
water is hot. (See "Dishwasher Efficiency Tips.") Turn off the
water and hook the dishwasher to the faucet. (See
"Connecting the Dishwasher.") Turn on the hot water.
i
Q
7. Press the desired cycle and option selections. (See
"Dishwasher Use.") Turn the Cycle Control knob to the
desired cycle to start.
CONNECTING THE
DISHWASHER
NOTE: A special adapter must be installed on the faucet before
the dishwasher can be connected. Complete Installation
Instructions and the adapter are packed with your dishwasher.
(See the Installation Instructions.)
When moving your dishwasher, make sure the door is latched.
Hold the dishwasher at the top front corners.