Installation; Installation Requirements - Kenmore 580.73083 Owner's Manual

Remove packingsheet from the backof the sleeve,and
packingcomer and bluetape fromthe air conditioner.
INSTALLATION REQUIREMENTS
If you use an existing wall sleeve, you should
measureits dimensions.
Install the new air conditioner according to these
installation instructions t o achievethe best
performance. A ll wall sleevesusedto mountthe
new air conditioner mustbe in goodstructural
condition and have a rear grilleto securelyattach
the new air conditioner.(FIG. 1)
With the Kenmore sleeve, youcan maintainthe
bestperformanceofthe new air conditioner. (FIG. 2)
(366ram)
!8"(458 ram)
Air Conditioner . FIG. 1
INSTALLATION HARDWARE
&
2 Size options
ITEM NAME OF PARTS Oq'Y
O PLASTIC GRILLE f
HORIZONTAL INSULATION STRIPS 2
_) AROUND INSULATION STRIPS 2
_) SUPPORT BLOCK 2
BAFFLE 1
(_ TRIM FRAME 2
(_ SHIM 2
(_) PLASTICNUTSAND WASHERSCREWS 4
Expanded
aluminum metal g_itlc
/. (425 m'_l
I
Kenmore Wall Sleeve FIG. 2
ELECTRICAL SERVICE
Check your available electrical service. The power
supply available must be the same as that shown
on the unit nameplate (found on left side of cabinet).
All models are equipped with a 3-prong service plug
to provide proper service and safe positive
grounding. Do not change plug in any way. Do not
use an adapter plug. If your present wall outlet does
not match your plug, calf a qualified electrician to
make the necessary corrections. SAVE CARTON
for storage and this OWNER'S MANUAL for future
reference. The carton is the best way to store unit
during winter or when not in use.
To avoid risk of personal injury, property damage,
or product damage due to the weightof this
device and sharp edges that may be exposed:
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• Carefully inspect location where air conditioner
will be installed. Be sure it will support the weight
of the unit over an extended period of time.
• Handle air conditioner with care. Wear
protective gloves whenever lifting or carrying the
unit. AVOID the sharp metal fins of front and
rear coils.
• Make sure air conditioner does not fall during
installation.
REQUIRED TOOLS:
• Tight Fitting gloves
• Standard screwdriver
• Phillips screwdriver
• Pliers
• Sharp knife
• 3/8-inch open end
wrench or adjustable
wrench
• 1/4-inch hex socket
and ratchet
• Tape measure
• Electric drill
• 1/4-inch drill bit
-5-