Extension Cables; Mains Supply; Operation; Maintenance And Storage - Black & Decker GS2400 Original Instructions Manual

Your appliance is designed for use on AC (mains)
u
electrical supplies only. Do not attempt to use it on any
other supply.

Extension cables

When using the appliance outdoors, only use extension
u
cables intended for outdoor use.
Up to 25 m 1.5 mm 3-core extension cable can be used
u
without loss of power.

Mains supply

The product meets the technical requirements of
EN 61000-3-11. This equipment is subject to conditional
connection and the user, in consultation with the supply
authority if necessary, shall be instructed to connect it only to
a supply of impedance 0.087 + j0.087 Ohm or less.

Operation

Before starting the appliance, look into the feeding
u
chamber to make certain that it is empty.
Keep your face and body away from the feed intake
u
opening, long branches may lash out when being pulled in
by the cutting gear. Do not allow hands or any other part
of the body or clothing inside the feeding chamber,
discharge chute, or near any moving part.
Keep proper balance and footing at all times. Do not
u
overreach. Never stand at a higher level than the base of
the appliance when feeding material into it.
Always stand clear of the discharge zone when operating
u
this appliance.
When feeding material into the appliance be extremely
u
careful that pieces of metal, rocks, bottles, cans or other
foreign objects are not included.
If the cutting mechanism strikes any foreign objects or if
u
the appliance starts making any unusual noise or
vibration, turn the appliance off, remove the plug from the
mains and allow the appliance to stop.
- Inspect the appliance for damage.
- Check for and tighten any loose parts.
- Have any damaged parts replaced or repaired with
original parts by an authorised repair agent.
Do not allow processed material to build up in the
u
discharge zone; this may prevent proper discharge and
can result in kickback of material through the feed intake
opening.
If the appliance becomes clogged, turn the appliance off,
u
remove the plug from the mains and allow the appliance to
stop before clearing debris.
Keep all guards and deflectors in place and in good
u
working condition.
Do not transport or tilt the appliance whilst in operation.
u
Do not leave the appliance unattended. Whenever you
u
leave the work area, turn the appliance off, remove the
plug from the mains and allow the appliance to stop.
Children must be supervised to ensure they do not play
with the appliance.
Do not tilt the appliance while the power source is running.
u

Maintenance and storage

When the appliance is stopped for servicing, inspection, or
u
storage, or to change an accessory, turn the appliance off
and remove the plug from the mains. Make sure that all
moving parts have come to a complete stop before
making any inspections, adjustments, etc.
Store the appliance in a dry and locked location.
u
Children should not have access to stored appliances.
The following warning symbols are found on the appliance:
t
Read the manual prior to operation.
Danger - rotating blades. Keep hands and feet out of
R openings.
Do not use the tool in wet conditions of expose it to
F
rain.
Always wear eye protection.
Before performing any maintenance, switch off and
unplug the appliance.
Keep bystanders away.
Always wear safety glasses, ear protection and a
G
respirator.
Wear gloves when operating this tool.

Electrical safety

If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
7