Before use, check that the mains voltage
corresponds to the voltage on the rating plate.
This appliance is double insulated in
accordance with EN 60335-2-14;
therefore no earth wire is required.
To avoid the risk of electric shock, do not
immerse the cord, plug or motor unit in water or
Check that the supply voltage shown on the
rating plate of the appliance matches that of
your electrical system. Any connection error
will invalidate the guarantee.
This appliance is supplied fully assembled &
only requires parts to be cleaned before use.
See "Cleaning" for details.
1. Fit the jug (4) onto the motor base (5) ensuring
that the power cord is at 180 degrees to the
2. Place the pulp strainer (3) in the jug, over the
top or the motor base and rotate until it gently
clicks into position.
3. Place the reamer (2) over the spindle of the
Prepare the fruit by rolling it gently between the
hands for a moment or two then cut it in half.
Connect the appliance to a suitable electrical
Press the cut face onto the reamer. Pressing
on the reamer will start the motor in the base.
The reamer will rotate, cutting into the fruit and
the juice will flow into the jug.
Note: Ensure fingers & hands do not touch the
reamer during operation. Never allow loose
clothing, jewelery, hair, etc. to come in contact
with moving parts.
The juicer will automatically stop once you stop
applying downward pressure on the reamer (2)
with the fruit.
Once juicing is completed, the lid (1) can be
placed over the unit.
The jug (4) can be removed & used to serve
The appliance should be disconnected
from the mains supply before removing
After 3 minutes of use, the Juicer should be
allowed to room temperature before further use.
Choose fresh, ripe fruit as they will yield
Drink the juice immediately after you have
extracted it. If it is exposed to air for some
time, the juice will lose its taste and
Maintenance & cleaning
The appliance is easier to clean if you do so
immediately after use.
Do not use abrasive cleaning agents,
scourers, acetone, alcohol etc. to clean the
All detachable plastic parts are dishwasher-
Place the detachable plastic parts on the top
tray of the dishwasher. Make sure they are
placed well away from the heating element.
Clean the motor unit with a damp cloth.