Table of Contents
Advertisement
ml
Remove two nuts from
one end of the top panel
n
frame. Remove end
piece. Slide decorative panel into
panel frame. Replace end piece
using nuts.
112
I Attach the brace to the
I
top right front comer of
.
the refrigerator cabinet
with one screw. insert top grille flange
into cabinet trim channel and align
grille with top and side trim. Attach top
grille mounting panel assembly to
- brace with one screw. Fasten grille in
place with six screws.
Check that the power switch is in the
"ON" position. Attach top grille decora-
tive panel assembly to the keyhole
bracket on the frame and pull down to
secure. if the top grille decorative
panel does not tit evenly within frame,
the keyhole bracket can be moved
side to side by adjusting the bracket
screws or the decorative panel bracket
can be moved up or down by adjusting
the decorator panel bracket nuts.
Personal injury Hazard
Reinstall set screws after
door swing is set.
Failure to so could result in
personal injury.
lIzI
Check that doors can
W
open freely. if not, the
door stops or hinges
can be adjusted.
To adjust horizontally:
Loosen set
screw in top and bottom hinges with
Allen wrench. Determine the door
swing desired. Hold door in that
position and tighten the set screws.
The doors have stops at 90°, 115"
and 137" positions. if the door
stops cannot be adjusted to clear
countertops, the countertops may
need to be mitered. (Consult your
builder to adjust countertops.)
To adjust vertically: Loosen, do
not remove, top and bottom hinge
screws. Lift door and bottom hinge
to desired position. Tighten bottom
hinge screws and then top hinge
screws.
114
Check the water
I
connections at the
bottom of the refrigerator
again for leaking. Any leaking can
cause refrigerator and floor damage.
1151
Open both doors. Use
two screws to attach
W bottom grille to cabinet.
El
Put shelves and bins
into the refrigerator and
.
freezer compartments.
Remove protective film from door
frame.
1171
Move the ice maker arm
8
into the down position.
Set refrigerator and
freezer compartment controls to the
midpoint between "COLD" and
"COLDEST". Check that the
compressor is operating properly.
Check that ail five interior lights and
one exterior light above dispenser
area are working.
118.1
Use a drinking glass to
press ice dispenser bar.
You should hear the
motor and auger operating. Press
the glass against the water
dispenser bar. Dispense and
discard about 2 to 3 quarts of water
to remove air from system and
rinse tank.
To get the most efficient
use, from your new
built--in refrigerator,
read
your KitchenAid"
Use
and Care Guide. Keep
lnstallatr'on Instructions
and Guide close to
built--in refrigerator
for
easy reference.
Page 11
Advertisement
Table of Contents
