Handle Removal; Handle Installation; Removing And Replacing; Refrigerator Doors - LG LSC27935 Series Owner's Manual

HANDLE REMOVAL REMOVING AND REPLACONG REFROGERATOR
You may have to remove thedoorhandles tomove the DOORS
refrigerator through a narrow opening. SeeinstructionsBefore r emoving thedoors, remove thebase grille. S ee
below. "Base G rille Installation" forreference.
NOTE: To avoid damaging door surfaces when moving
the refrigerator through narrow openings, it is
ALWAYS recommended to remove the doors as
instructed in the next two pages.
, Loosen the set screws with a 3/32" (2,5 ram) Allen
wrench and remove the handle.
NOTE: If the handle mounting fasteners need to be
tightened or moved, use a 1/4" (6 ram) Allen
wrench.
To remove the right (refrigerator) door:
1. Open the door. Remove the top hinge cover screw (1).
2.Use a flat blade screwdriver to pry back the hooks
(not shown) of the hinge cover (2) from the top of the
refrigerator cabinet. Lift up the cover.
3. Rotate the hinge lever (3) clockwise. Lift the top hinge
(4) free of the hinge lever latch (5).
NOTE: Regardless of hinge lever type, removal process
is the same.
Set
4. Lift the door from the lower hinge pin.
5. Place the door, inside facing up, on a non scratching
surface.
/
Type 1 i (4I (51_
, Type 2
HANDLE iNSTALLATiON
Place the handle on the door by adjusting handle
footprints to fit mounting fasteners and tighten the set
screws with a 3/32" (2,5 ram) Allen wrench .
NOTE: If the handle mounting fasteners need to be
tightened or removed use a 1/4" (6 ram) Allen
wrench.
ELECTRIC SHOCK HAZARD
° Disconnect electrical supply to the refrigerator before
installing. Failure to do so could result in death or
serious injury.
° Do not put hands, feet or other objects into the air
vents, base grille, or bottom of the refrigerator. You
may be injured or receive an electrical shock.
° Be careful when you work with the hinge, base grille
and stopper. You may be injured. Before removing
the doors, remove the base grille.
CAUTION
When lifting the hinge free of the latch, be careful
that the door does not fall forward.
Removing the left (freezer) door with water line
connection:
Pull up the water feed tube while pressing the area (Figure
1) as shown in the figure below.
NOTE:
If a tube end is deformed oF abraded, trim the
part away. Disconnecting the tube under the door
causes about 0,13 gallons (0,5 liters) water to
flow out. Put a large container at end of tube to
prevent water from draining onto the floor.
1. Open the door. Remove the top hinge cover screw (1).
2.Use a flat blade screwdriver to pry back the hooks
(not shown) of the hinge cover (2) from the top of the
refrigerator cabinet (2). Lift up the cover.
3. Disconnect all the wire harnesses (3).
4. Remove the grounding screw (4).
5. Rotate hinge lever (5) counterclockwise. Lift the top
hinge (6) free of the hinge lever latch (7).
NOTE: Regardless of hinge lever type, removal process
is the same.