Lubricating The Drive Chain - Yamaha FZS1000N Owner's Manual

NOTE:
_
Using the alignment marks on each
side of the swingarm, make sure that
both chain pullers are in the same posi-
tion for proper wheel alignment.
_
CAUTION:
_
Improper drive chain slack will over-
load the engine as well as other vital
parts of the motorcycle and can lead
to chain slippage or breakage. To
prevent this from occurring, keep
the drive chain slack within the
specified limits.
_
3. Tighten the locknuts, and then
tighten the axle nut to the specified
torque.
Tightening torque:
Axle nut:
150 Nm (15.0 m·kgf, 108 ft·lb)
PERIODIC MAINTENANCE AND MINOR REPAIR

Lubricating the drive chain

The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
EC000096
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
CAUTION:
_
The drive chain must be lubricated
after washing the motorcycle or
riding in the rain.
_
1. Clean the drive chain with kero-
sene and a small soft brush.
CAUTION:
_
To prevent damaging the O-rings,
do not clean the drive chain with
steam cleaners,
washers or inappropriate solvents.
_
6-32
EAU03006 2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive
chain with a special O-ring chain
lubricant.
CAUTION:
_
Do not use engine oil or any other
lubricants for the drive chain, as
they may contain substances that
EC000097
could damage the O-rings.
_
ECA00053
high-pressure
ECA00052
6