Replacing A Headlight Bulb - Yamaha YZFR1W(C) Owner's Manual

To replace a fuse
If a fuse is blown, replace it as follows.
1. Turn the key to "OFF" and turn off
the electrical circuit in question.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
Specified fuses:
Main fuse:
50.0 A
Headlight fuse:
25.0 A
Signaling system fuse:
7.5 A
Ignition fuse:
15.0 A
Radiator fan fuse:
15.0 A × 2
Fuel injection system fuse:
15.0 A
Backup fuse:
7.5 A
Electric throttle valve fuse:
7.5 A
PERIODIC MAINTENANCE AND MINOR REPAIR
CAUTION:
Do not use a fuse of a higher amper-
age rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
3. Turn the key to "ON" and turn on
the electrical circuit in question to
check if the device operates.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
6-37
ECA10640

Replacing a headlight bulb

1. High beam headlight bulb
2. Low beam headlight bulb
This model is equipped with quartz bulb
headlights. If a headlight bulb burns
out, replace it as follows.
To replace a high beam headlight
bulb
1. Remove panel C (if replacing the
left headlight bulb) or panel D (if re-
placing the right headlight bulb).
(See page 6-9.)
2. Disconnect the headlight coupler,
and then remove the bulb cover.
EAU42930
6