Adjusting Boat Trim - Yamaha 8 Owner's Manual

Operation
1
1. Trim rod
3. Reposition the rod in the desired hole.
To raise the bow ("trim-out"), move the rod
away from the transom.
To lower the bow ("trim-in"), move the rod to-
ward the transom.
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
EWM00400
WARNING
Stop the engine before adjusting the
G
trim angle.
Use care to avoid being pinched when
G
removing or installing the rod.
Use caution when trying a trim position
G
for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
TIP:
The outboard motor trim angle can be
changed approximately 4 degrees by shifting
the trim rod one hole.
EMU27912

Adjusting boat trim

When the boat is on plane, a bow-up attitude
results in less drag, greater stability and effi-
ciency. This is generally when the keel line of
the boat is up about 3 to 5 degrees. With the
37
bow up, the boat may have a greater tenden-
cy to steer to one side or the other. Compen-
sate for this as you steer. When the bow of
the boat is down, it is easier to accelerate
from a standing start onto plane.
ZMU02859
Bow Up
Too much trim-out puts the bow of the boat
too high in the water. Performance and econ-
omy are decreased because the hull of the
boat is pushing the water and there is more
air drag. Excessive trim-out can also cause
the propeller to ventilate, which reduces per-
formance further, and the boat may "por-
poise" (hop in the water), which could throw
the operator and passengers overboard.
Bow Down
Too much trim-in causes the boat to "plow"
through the water, decreasing fuel economy
and making it hard to increase speed. Oper-
ating with excessive trim-in at higher speeds
also makes the boat unstable. Resistance at