Clutch Lever - Yamaha FZS10X Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
Dimmer switch "
Set this switch to "
beam and to " " for the low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
3
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
Start switch " "
Push this switch to crank the engine
with the starter.
EAU12400
/ "
CAUTION:
" for the high
See page 5-1 for starting instruc-
tions prior to starting the engine.
EAU12460
/ "
The engine trouble warning light will
come on when the key is turned to "ON"
and the start switch is pushed, but this
". When re-
does not indicate a malfunction.
Hazard switch "
With the key in the "ON" position, use
this switch to turn on the hazard lights
EAU12500
(simultaneous flashing of all turn signal
lights).
The hazard lights are used in case of
EAU12660 an emergency or to warn other drivers
/ "
when your vehicle is stopped where it
" before starting
might be a traffic hazard.
" to
CAUTION:
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
EAU12710
tery may discharge.
ECA10050

Clutch lever

EAU41700
EAU12765
1. Clutch lever
"
The clutch lever is located at the left
handlebar grip. To disengage the
clutch, pull the lever toward the handle-
bar grip. To engage the clutch, release
the lever. The lever should be pulled
rapidly and released slowly for smooth
clutch operation.
The clutch lever is equipped with a
ECA10061
clutch switch, which is part of the igni-
tion circuit cut-off system. (See page
3-19.)
3-9
EAU12820