Yamaha FZS10X Owner's Manual page 23

eter display will automatically change to
the fuel reserve tripmeter mode "F-
TRIP" and start counting the distance
traveled from that point. In that case,
push the "SELECT" button to switch the
display between the various tripmeter
and odometer modes in the following
order:
F-TRIP → TRIP A → TRIP B → ODO
→ F-TRIP
To reset a tripmeter, select it by push-
ing the "SELECT" button, and then
push the "RESET" button for at least
one second. If you do not reset the fuel
reserve tripmeter manually, it will reset
itself automatically and the display will
return to the prior mode after refueling
and traveling 5 km (3 mi).
INSTRUMENT AND CONTROL FUNCTIONS
Fuel meter
1. Fuel meter
The fuel meter indicates the amount of
fuel in the fuel tank. The display seg-
ments of the fuel meter disappear to-
wards "E" (Empty) as the fuel level
decreases. When the last segment on
the left starts flashing, refuel as soon as
possible.
NOTE:
This fuel meter is equipped with a self-
diagnosis system. If the electrical circuit
is defective, the following cycle will be
repeated until the malfunction is cor-
rected: "E" (Empty), "F" (Full) and
symbol " " will flash eight times, then
3-6
go off for approximately 3 seconds. If
this occurs, have a Yamaha dealer
check the electrical circuit.
Coolant temperature mode
1. Coolant temperature display
The coolant temperature display indi-
cates the temperature of the coolant.
Push the "RESET" button to switch the
coolant temperature display to the air
intake temperature display.
NOTE:
When the coolant temperature display
is selected, "C" is displayed for one
second, and then the coolant tempera-
ture is displayed.
3