Power Trim And Tilt / Power Tilt Will Not Operate; Starter Will Not Operate - Yamaha 150 Owner's Manual

Trouble Recovery
1
2
1. Fuse holder
2. Fuse (20 A, 30 A)
NOTE:
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU29522
Power trim and tilt / power tilt will not
operate
If the engine cannot be tilted up or down with
the power trim and tilt / the power tilt because
of a discharged battery or a failure with the
power trim and tilt unit / the power tilt unit, the
engine can be tilted manually.
1. Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
1. Manual valve screw
2. Put the engine in the desired position,
then tighten the manual valve screw by
63
turning it clockwise.
EMU29532

Starter will not operate

If the starter mechanism does not operate
(the engine cannot be cranked with the start-
er), the engine can be started with an emer-
gency starter rope.
EWM01021
WARNING
Use this procedure only in an emergen-
ZMU03919
G
cy to return to the nearest port for re-
pairs.
When the emergency starter rope is
G
used to start the engine, the start-in-
gear protection device does not oper-
ate. Make sure the remote control lever
is in neutral. Otherwise the boat could
unexpectedly start to move, which
could result in an accident.
Attach the engine stop switch lanyard
G
to a secure place on your clothing, or
your arm or leg while operating the
boat.
Do not attach the lanyard to clothing
G
that could tear loose. Do not route the
cord where it could become entangled,
preventing it from functioning.
Avoid accidentally pulling the lanyard
G
during normal operation. Loss of en-
gine power means the loss of most
steering control. Also, without engine
power, the boat could slow rapidly. This
could cause people and objects in the
1
boat to be thrown forward.
Make sure no one is standing behind
G
you when pulling the starter rope. It
ZMU03464
could whip behind you and injure
someone.
An unguarded, rotating flywheel is very
G
dangerous. Keep loose clothing and
other objects away when starting the