Korg PS60 User Manual page 23

Performance synthesizer editor/plug-in editor

Hide thumbs Also See for PS60:

Table of Contents

Mode (PERF, PROG EDIT, GLOB) / Utility (UTILITY):

Here you can select performance, program edit, or global mode. UTILITY lets you view and select

the utility commands that are available for the page you've selected.

This is where you can save data.

Performance (Program) Number, Name:

This indicates the number and name of the performance or program. In Performance mode, you

can use the up/down arrows located at the right to switch performances, or click the performance

name to open the browser and view a list of performances.

Edit Pages, Tabs:

These are used to select the page that you want to edit.

Performance Control:

EASY SETUP:

Here you can specify the function of the six knobs, and control each timbre's volume, octave, and

MFX 1/2 send levels.

Timbre Selector:

Here you can turn each timbre on/off.

SPLIT SETTING / CTRL:

Here you can choose the split setting.

This function is different than the PS60's own SPLIT SETTING button; it specifies the internal

state.

* SUB OFF: Split off

* MAIN LOWER: Assign the main timbres to the region at the left of the split point (lower region)

* MAIN UPPER: Assign the main timbres to the region at the right of the split point (upper

region)

CTRL:

This switches the EASY SETUP and Timbre Selector functionality shown in Easy Setup. MAIN is

always shown if SUB OFF is selected.

Effect:

Here you can edit the MFX1 (MODULATION), MFX2 (REVERB/DELAY) and EQ parameters.

If MFX1 or MFX2 are off (checkbox), the effect name is grayed-out.

Keyboard:

This section consists of an 88-note keyboard, a pitch bend wheel, and a modulation wheel.

You can click the keyboard to play notes, and even play a glissando by dragging over the keyboard

to the left or right. You can use the pitch bend wheel and modulation wheel by dragging them

upward or downward.

Table of Contents