IBM 22P6415 User Manual page 46

To add a Virtual Server, do the following:
1. From the left-hand navigation bar, click Advanced Configuration
Server Configuration to display the Virtual Server table.
You can enable or disable the Virtual Server function by selecting Enable or
Disable from the pull-down menu at the top of the table.
Note: It is recommended that you click Enable and Apply before entering
specific virtual server information.
2. To add a Virtual Server, click Add.
v Virtual Server: Enable or disable the Virtual Server on the LAN. Only an
enabled server can be accessed through the Gateway from the Internet.
v Global Port: TCP or UDP port number used by the Gateway on the
Internet-broadband port. This is the port number visible to users in the
Internet, and is also known as the External Port Number.
v Local IP: IP address of the server computer on the LAN.
v Local Port: TCP or UDP port number used by the server computer on
the LAN. Designated external port numbers are translated into this
internal port number.
v Protocol: Specifies the TCP or UDP port number by selecting the
appropriate protocol. Most well-known protocols have default port
numbers defined by various standards.
v Remark: Type any comments about your server.
The port specified on the IP address specified for Virtual Server is exposed to
the internet. It will not be protected by the internal firewall.
®
5-18
IBM High Rate Wireless LAN Gateway: User's Guide
Virtual