Advertisement
Installation instructions
EXHAUST
CONNECTION
_WARNING
- TO REDUCE
THE
RISK
OF FIRE OR PERSONAL
INJURY:
• This dryer
must be exhausted
outdoors.
• Use only metal duct.
• Do not terminate
_'xhaust in a chimney,
any gas vent,
under
an enclosed
floor (crawl space), or into an attic.
The accumulated
lint could create
a fire hazard.
- Provide
an access for inspection
and cleaning
of the
exhaust
system,
especially
at turns. Inspect
and clean at
least once a year,
o Never
terminate
the exhaust
into a common
duct with a
kitchen
exhaust.
A combination
of lint and grease
could
create
a fire hazard.
• Do not obstruct
incoming
or exhausted
air.
THiS DRYER COMES READY FOR REAR
EXHAUSTING. iF SPACE iS LIMITED, USE
THE iNSTRUCTIONS iN SECTION 9 TO
EXHAUST DIRECTLY FROM THE SIDES OR
BOTTOM OF THE CABINET.
STANDARD
REAR EXHAUST
(Vented
at floor
level)
FOR STRAIGHT
LINE iNSTALLATiON,
CONNECT THE
DRYER E XHAUST
TOTHE EXTERNAL
EXHAUST H OOD USING
DUCT TAPE ORCLAMP.
--:
(CORD NOT SUPPLIED
:""
WITH DRYER)
CUTTHEMETALEXHAUST
DUCT(NOTSUPPLIED)
TOTHE
PROPER LENGTH.
NOTE: WESTRONGLY RECOMMEND
SOLID METAL E XHAUST DUCTING.
HOWEVER,
IFFLEXIBLE D UCTING I SUSED ITMUST BEMETAL N OTPLASTIC.
STANDARD
REAR EXHAUST
{Vented
above
floor
level)
ELBOW HIGHLY
RECOMMENDED
ELBOW HIGHLY
RECOMMENDED
RECOMMENDED
CONFIGURATION
TOMINIMIZE
EXHAUST
BLOCKAGE.
NOTE: ELBOWS WiLL PREVENT
DUCT
KiNKiNG
AND COLLAPSING.
[_ LEVELING AND STABiLiZiNG
YOUR DRYER
STAND THE DRYER U PRIGHT NEAR THEFINAL LOCATION ANDADJUST
THE 4 LEVELING LEGS, ATTHE CORNERS, TOENSURE THAT THEDRYER
iSLEVEL F ROM SiDE TOSIDE ANDFRONT T OREAR.
LEVEL
FRONT-TO-BACK.
LEVEL
"_
SIDE-TO-SiDE.
4 LEVELING
LEGS
Advertisement
