Kenmore 116.33728 Owner's Manual page 19

Iiili iiiiiiiiiiiiiiiiiiiii iii!ii!i!iiiiii iiii i iii £i i ii iiliii i iii, i
I
Always follow all safety precautions when
cleaning and servicing the vacuum cleaner.
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in elec-
trical shock or personal injury from
cleaner suddenly starting.
If the cleaner does not seem to have ade-
quate suction, first check if the dust bin is
full or if a filter is clogged. See DUST BIN
CLEANING and FILTER CHANGING.
Check the suction inlet area. Remove any
visible clogs.
If the dust bin and filter areas are free of
clogs, check the hose area. Remove exten-
sion wand from the connector pipe by
grasping the extension wand, twisting, and
pulling straight off.
Suction
Inlet
Pipe
Visually inspect the hose and the base area
into which the hose is connected.
Remove any visible clog.
With the vacuum running, stretch the hose
to maximum length and then allow the hose
to return to its storage length.
Reconnect extension wand to hose and
connector pipe.
Turn the unit off and unplug the unit.
Remove dust bin and check dust bin port
and secondary screen for clogs. If the dust
bin and filter areas and the hose areas are
free of clogs, check the nozzle area. To
check this area, see the section on AGITA-
TOR CLEANING.
Return the cleaner to the upright position,
check short hose for clogs.
Alignment
Notch
Alignment.
Tab
18
Screw
Hose
The short hose is fastened to the connector
pipe. To remove short hose and connector
pipe, remove screw from connector pipe.
Stretch the hose and connector pipe to
maximum length and then allow the hose to
return to its original length.
_ Screw _
When reinstalling the hose and connector
pipe align the notch in the body with the tab
on the connector pipe. Reinstall with screw
removed earlier.
Return the cleaner to the upright position
before plugging into an electrical outlet.
Personal Injury Hazard
DO NOT place hands or feet under-
neath the unit at any time. The agita-
tor will be revolving rapidly when the
vacuum is turned on and is in the
carpet setting.