Hide thumbs Also See for LMD-2451TD:
Table of Contents

Advertisement

Submenu
Setting
PARALLEL REMOTE
Selects the PARALLEL REMOTE
connector pins for which you want
to change the function.
You can assign various functions to
1 to 4 pins and 6 to 8 pins. The
following lists the functions you
can assign to the pins.
• – – – (“– – –”: No function is
assigned.)
• COMPOSITE
• Y/C
• RGB
• COMPONENT
• DVI
• HD15
• OPTION A-1
• OPTION A-2
• OPTION B-1
• OPTION B-2
• OVERSCAN
• FULL
• NORMAL
• NATIVE
• 4:3
• 16:9
• TALLY R (LMD-2451TD)
• TALLY G (LMD-2451TD)
• EXT SYNC
• BLUE ONLY
• MONO
• H/V DELAY
• 16:9 MARKER
• 15:9 MARKER
• 14:9 MARKER
• 13:9 MARKER
• 1.85:1 MARKER
• 2.35:1 MARKER
• 1.85:1 & 4:3 MARKER
• 4:3 MARKER
• CENTER MARKER
• SAFE AREA 80%
• SAFE AREA 85%
• SAFE AREA 88%
• SAFE AREA 90%
• SAFE AREA 93%
• MARKER MAT HALF
• MARKER MAT BLACK
• 2D/3D SELECT
• CHECKER BOARD
• L/R SWITCH
• HOROPTER CHECK
• DISPARITY SIM.
Notes
• If you use the PARALLEL
REMOTE function, you need to
connect cables. For more details,
see page 38.
• Set MARKER ENABLE
(page 29) to ON to control the
aspect marker, center marker or
safe area marker.
Submenu
Setting
SERIAL REMOTE
Selects the mode to be used.
• OFF: SERIAL REMOTE does
not function.
• RS-232C: The monitor is
controlled by the command of
RS-232C.
• ETHERNET: The monitor is
controlled by the command of
Ethernet.
• BKM-15R: Sets BKM-15R.
MONITOR
Sets the monitor setting.
MONITOR ID: Sets the ID
of the monitor.
GROUP ID: Sets the group
ID of the monitor.
IP ADDRESS: Sets the IP
address.
SUBNET MASK: Sets the
subnet mask.
(255.255.255.000)
DEFAULT GATEWAY:
Sets the default gateway on
or off.
ADDRESS: Sets the default
gateway.
CANCEL: Selects to cancel
the setting.
CONFIRM: Selects to save
the setting.
CONTROLLER
Sets the address of the remote
controller.
IP ADDRESS: Sets the IP
address.
SUBNET MASK: Sets the
subnet mask.
(255.255.255.000)
DEFAULT GATEWAY:
Sets the default gateway on
or off.
ADDRESS: Sets the default
gateway.
CANCEL: Selects to cancel
the setting.
CONFIRM: Selects to save
the setting.
CONNECTION
Sets the connection of the monitor
and the controller.
PEER TO PEER: for one
to one connection
LAN: for connection via a
network

KEY INHIBIT menu

KEY INHIBIT
K E Y I N H I B I T :
xx
Page 35
Adjustment Using the Menus

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lmd2451tdpac2Lmd4251tdpac2

Table of Contents