Advertisement
QuickSpecs
Standard Features
Server Power Cords
Power Supply
System Fans
Required Cabling
OS Support
Rack Airflow
Requirements
One Lowline power cord ships standard
300 Watts, PFC (Power Factor Correcting)
1 system fan ships standard. 1 system fan total supported (does not include fans integral to CPU
heatsink or power supply assemblies).
For required cabling information, refer to the HP Web site at
http://h18000.www1.hp.com/products/servers/ProLiantML330/.
Microsoft Windows 2000 (Server and Advanced Server)
Microsoft Small Business Server 2000
Microsoft Small Business Server 2003
Windows Server 2003
Novell NetWare
Novell NetWare Small Business Server 6.0
Linux (Red Hat, SuSE, UnitedLinux)
NOTE: For a more complete and up-to-date listing of supported OS's and versions, please visit
our OS Support Matrix at:
NOTE: For a more complete and up-to-date information on Linux support, please visit HP Linux
Web site at:
http://h18004.www1.hp.com/products/servers/linux/hpLinuxcert.html
NOTE: For an up-to-date listing of the latest drivers available for the HP ProLiant ML330, please
see:
http://h18023.www1.hp.com/support/files/server/us/index.html.
NOTE: For more complete and up-to-date information on how to buy server operating systems
from HP please visit the OS product site at:
http://h18004.www1.hp.com/products/servers/software/OEM.html
Rack 10000 series Cabinets
The increasing power of new high-performance processor technology requires increased cooling
efficiency for rack-mounted servers. The 10000 Series Racks provide enhanced airflow for
maximum cooling, allowing these racks to be fully loaded with servers using the latest processors.
CAUTION: If a third-party rack is used, observe the following additional requirements to ensure
adequate airflow and to prevent damage to the equipment:
Front and rear doors: If your 42U server rack includes closing front and rear doors,
you must allow 830 square inches (5,350 sq cm) of hole evenly distributed from top to
bottom to permit adequate airflow (equivalent to the required 64 percent open area for
ventilation).
Side: The clearance between the installed rack component and the side panels of the
rack must be a minimum of 2.75 inches (7 cm).
CAUTION: Always use blanking panels to fill all remaining empty front panel U-spaces in the rack.
This arrangement ensures proper airflow. Using a rack without blanking panels results in improper
cooling that can lead to thermal damage.
NOTE: For additional information, refer to the Setup and Installation Guide or the Documentation
CD provided with the server, or to the server documentation located in the Support section at the
following URL: http://h18000.www1.hp.com/products/servers/ProLiantml330/index.html.
DA - 11614 Worldwide QuickSpecs — Version 44 — 6.28.2005
http://h10018.www1.hp.com/wwsolutions/index.html
HP ProLiant ML330 Generation 3
Page 6
Advertisement
