Defrost Control Assembly; Lamp; Control Box-Refrigerator - Kenmore 795.77562600 Service Manual

* Ice Fan Scroll Assembly Replacement
1) Remove the plastic guide for the slides on left side by
unscrewing the phillips head screws.
2) Pull the grille forward as shown in the second picture.
3) Disconnect the wire harness of the grille
4) Remove the scroll assembly by loosening 2 screws
(1)
(3)

8-5 DEFROST CONTROL ASSEMBLY

The defrost Control assembly consists of the Defrost
Sensor and the FUSE-M.
The Defrost Sensor works to defrost automatically. It is
attached to the metal side of the Evaporator and senses its
temperature. At 72°C, it turns the Defrost Heater off.
Fuse-M is a safety device for preventing overheating of
the Heater when defrosting.
1. Pull out the grille assembly. (Figure 12)
2. Separate the connector with the Defrost Control
assembly and replace the Defrost Control assembly
after cutting the Tie Wrap. (Figure 13)
GRILLE ASSEMBLY
Figure 12
(2)
(4)
DEFROST-CONTROL
ASSEMBLY
Figure 13
- 56 -

8-6 LAMP

8-6-1 Refrigerator Compartment Lamp
1. Unplug the Refrigerator or disconnect power at the
circuit breaker.
2. If necessary, remove the top shelf or shelves.
3. Using a flat instrument, gently pry the cover loose in the
front as shown. Rotate downward to remove rear tabs.
4. Make sure the bulbs are cool to the touch.
Turn bulbs counterclockwise to remove.
5. Assemble in reverse order by snapping the Lamp Cover
in, engaging the rear tabs followed by the front tabs.
(Max. 60 W-2EA)
8-6-2 Freezer Compartment Lamp
1. Unplug refrigerator power cord form outlet.
2. Using a flat instrument, gently pry the lamp cover
loose in the front as shown. Rotate downward to
remove the rear tabs.
3. Make sure the bulb is cool to the touch. Turn the
bulb counterclockwise to remove.
4. Replace with a new 60-watt appliance bulb.
5. Insert tabs on back of cover into slots in freezer
ceiling. Push cover up to snap front into place.

8-7 CONTROL BOX-REFRIGERATOR

1. First, remove all shelves in the refrigerator, than remove
the Refrigerator control Box by loosening 2 screws.
CONTROL BOX
COVER LAMP
2. Remove the Refrigerator Control Box by pulling it
downward.
3. Disconnect the lead wire on the right position and
separate the lamp sockets.
Figure 14
Figure 15
Figure 16