Door Alignment; Fan And Fan Motor (Evaporator) - Kenmore 795.77562600 Service Manual

2) Press the gasket into the channels on the three
remaining sides of door.
3. Replace door frame cover
Starting at the top of the cover and working down, snap
the cover back into door.
.

8-3 DOOR ALIGNMENT

If the space between your doors is uneven, follow the
instructions below to align the doors:
1. With one hand, lift up the door you want to raise at the
the middle hinge.
2. With the other hand, use pliers to insert the snap ring as
shown.
3. Insert additional snap rings until the doors are aligned.
(Three snap rings are provided with unit.)
Figure 6
Figure 7

8-4 FAN AND FAN MOTOR (EVAPORATOR)

1. Remove the freezer shelf.
2. Remove the plastic guide for the slides on left side by
unscrewing the phillips head screws.
3. Remove the grille by removing one screw and pulling the
grille forward.
4. Remove the Fan Motor assembly by loosening 2 screws
and disassembling the shroud.
5. Pull out the fan and separate the Fan Motor and Bracket.
BRACKET
- 55 -
FAN MOTOR
MOTOR
GRILLE
Figure 10
FAN
Figure 11