Cisco 765 Series Router Commands; Verify The Configuration - Cisco 700 Series Configuration Manual

PAT with IPCP Single-Destination Negotiation Example

Cisco 765 Series Router Commands

Following are the commands for configuring the remote Cisco 765 series router for PAT
with IPCP single-destination negotiation with a Cisco 4500 router:
set system 765
set ip pat po ftp 10.0.0.2
cd lan
set ip address 10.0.0.1
set ip netmask 255.0.0.0
set ip routing on
set user 4500
set active
set 1 number phone_number
set 2 number phone_number
set ip routing on
set ip rip version 2
set ip rip receive v2
set ip pat on
reboot
For detailed information regarding the commands listed here, refer to the Cisco 700 Series
Router Command Reference.

Verify the Configuration

When a demand call is made, you can use the show ip config all and show ip route all
commands to see the IPCP negotiation address.
You can use the show ip pat command to see the services returned by PAT.
5-10 Cisco700 Series Router Configuration Guide