Ip Rip Authentication Key-Chain; Ip Rip Authentication Mode; Ip Rip Authentication String; Passive-Interface - HP MSM7XX Reference Manual

CLI commands
<internal addr>
<internal-port>

ip rip authentication key-chain

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
ip rip authentication key-chain <name>
Specifies a keyed MD5 chain.
no ip rip authentication key-chain
Do not use this Keyed MD5 chain.

ip rip authentication mode

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
ip rip authentication mode (md5 | text)
Select RIPv2 authentication mode.
no ip rip authentication mode
Use no RIPv2 authentication.

ip rip authentication string

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
ip rip authentication string <secret>
Sets the RIP shared password.
no ip rip authentication string
Clears the RIP shared password.

passive-interface

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
passive-interface
Sets RIP to operate in passive mode (listen for routing broadcasts to update the routing table, but
do not broadcast own routes).
no passive-interface
Sets RIP to operate in active mode (listen for routing broadcasts to update the routing table, and
also broadcast own routes).

router rip

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
router rip
Enable RIP.
no router rip
Disable RIP.
2-82
IP address of the device on the internal network that traffic will be routed
to.
The protocol port number that the incoming traffic will be mapped to.