Frigidaire 242111904 Use & Care Manual page 11

7
8
9
With steel clamp and screw, secure water
supply line (copper tubing only] to rear
panel of refrigerator as shown.
Coil excess water supply line (copper
tubing only), about 21/2turns, behind
refrigerator as shown and arrange coils so
they do not vibrate or wear against any
other surface.
Turn ON water supply at shutoff valve and
tighten any connections that leak.
Reconnect refrigerator to electrical power
source.
To turn ice maker on, lower wire signal
arm (side mounted) or set the ice maker's
On/Off power switch to the 'T' position
(rear mounted).
Plastic Water
Tubing to Ice P
Maker Fill , Brass
Compression
Nut
J" [_ -Copper
water line
S,b// rater Va w
/_ _ :t_, Yc"_X Bracket
///
/// ///_c_, - Valve Inlet
l(l__ _- Water Valve
• Copper water line
from household
_ water supply
J (oln_llUdemenough tubing in loop
to allow moving refrigerator out
for cleaning.)
Figure 1
Plasti_
to Ice Maker
11 Tube
Clamp
_s
Steel
water line
"Water Valve
Bracket
\ Water Valve
.6 ft. Stainless Steel water line
_f from household water supply
Figure 2
IMPORTANT
After connecting the water supply, refer to
"How to Prime the Water Supply System"
for important information about priming an
empty water supply system
Your refrigerator's water supply system
includes several tubing lines, a water filter,
a water valve, and a water tank. To ensure
that your water dispenser works properly,
this system must be completely filled
with water when your refrigerator is first
connected to the household water supply
line.