Download Print this page

Kenmore 253.25003 Use & Care Manual page 6

Hide thumbs

Advertisement

Dehumidifier Feature
(continued)
4. You can also use the FAN SPEED button to change the fan speed to HIGH or LOW. The indicator light will show the setting
you have selected. A higher fan speed will result in quicker moisture removal.
5. The FILTER RESET light will illuminate after 250 hours of operation. At this time, refer to the "Care and Cleaning section
to remove and clean the filter. Once the filter has been cleaned, simply press the FILTER button to extinguish the light.
6. The TIMER function enables you to either Delay Start or Delay Stop the unit in the choice from 0.5 hour to 24 hours. If the
unit is running, then selecting Timer will turn the unit off after setting hours (Delay Stop). If the unit is off, then selecting
Timer will turn the unit on after setting hours (Delay Start).
TIMER setting: First press TIMER button, then to adjust timer setting, tap or hold the
timer at 0.5 hour increments, up to 10 hours, then by 1 hour increments up to 24 hours. The control will count down the
time remaining (8,7.5,7, etc.) until the unit either starts or stops. For the Delay Start, the fan speed and humidity
maintained will be the same as previous setting. After TIMER setting finishes, pressing TIMER button again at any time will
cancel the
TIMER function. The Delay Start/Stop Feature will work until the unit either starts ro stops. Once that happens, the above
steps will have to be repeated again.
NOTE: 1. Before entering TIMER setting, the power indicator must be lit to make sure power is being supplied to the unit.
2. Before entering TIMER setting, make sure first pressing HUMIDITY
or button sets one desired room humidity.
6
or button to change the delay

Hide quick links:

Advertisement

loading

This manual is also suitable for:

253.25001253.25002