If your refrigerator
has an automatic
it will provide a sufficient supply of ice for
normal use. During the initial startup of your
refrigerator, no ice will be produced during the
first 24 hours of operation. Air in new plumbing
lines may cause the ice maker to cycle two or
three times before making a full tray of ice.
With no usage, it will take approximately
to two days to fill the ice container.
New plumbing connections may cause the first
production of ice cubes to be discolored or
have an odd flavor. Discard ice made during
the first 24 hours.
Chemicals from a malfunctioning
Automatic ice makers are also optional
accessories that may be installed in most
models at any time. Call your local dealer for
YOUR ICE MAKER ON
After the plumbing connections
completed, the water supply valve must be
opened. Place the ice container under the
ice maker, pushing it as far back as possible.
Lower the wire signal arm to its "down" or ON
YOUR ICE MAKER OFF
To stop the ice maker, lift the wire signal
arm until it clicks and locks in the "up" or
OFF position. The ice maker also turns off
when the ice container is full.
If your model has an adjustable freezer shelf,
place the shelf in the lower position, so that
the wire signal arm will hit the ice when the
container is full.
can damage the ice maker. If the ice maker
is connected to soft water, ensure that the
softener is maintained
and working properly.
Your ice maker is shipped from the factory
with the wire signal arm in the ON position.
To ensure proper function of your ice maker,
hook up water supply immediately
ice maker OFF by lifting the wire signal arm
until it clicks and locks in the UP position.
If the ice maker
is not turned
supply is not connected,
will make a loud
The ice maker will produce 2.5 to 3 pounds
of ice every 24 hours depending on usage
Ice is produced at a rate of 8 cubes
every 75 to 160 minutes.
DO NOT place the ice container in your