Hot Surface Indicator Light - Frigidaire Built-In Range Use & Care Manual

BEFORE SETTING SURFACE CONTROLS
Element ON
(all models)
Your appliance is equipped with two different types of
radiant surface control indicator lights that will glow on
the backguard- the Element On indicator light and the
hot surface indicator lights.
The element ON indicator lights are located on the
control panel (Figure 1) between the two radiant element
control knob and will glow when a surface element is
turned ON.
Element ON indicator light location.
12
element ON
indicator
light
Figure 1

Hot surface indicator light

(Model C only)
The hot surface indicator light located on the cooktop
(Figure 2) will glow when any surface cooking area heats
up and will remain on until the glass cooktop has cooled
to a MODERATE level.
Figure 2 - Model C only
Hot surface indicator light location.
NOTE
The "Hot Surface" indicator lights will glow when the
element is turned on and will continue to glow after the
control knob is turned to the "OFF" position. It will glow
until the heating surface area has cooled suffi ciently.
The glass surface may still be hot and burns may
occur if the glass surface is touched before the indicator
light has turned OFF. The message may remain on even
though the controls are turned OFF.
hot surface
indicator
light