Maintenance; Cleaning The Water Inlet Filters - Kenmore 796.3151 Use & Care Manual

MAINTENANCE
Cleaning the Water inlet Filters
If the washer does not fill properly, an error message will
show on the display. The inlet valve filter screens coutd
be plugged by hard water scale, sediment in the water
supply, or other debris.
NOTE: The inlet screens protect the delicate parts of the
inlet valve from being damaged by particles that could
enter the valves with the water supply. Operating the
washer with these filters removed could cause a valve to
stick open resulting in flooding and/or property damage.
@
Inlet Filter
Turn OFF both water faucets completely. Unscrew the
hot and cold water lines from the back of the washer.
IMPORTANT: Only use inlet hoses provided by KENMORE.
Aftermarket hoses are not guaranteed to fit or func-
tion correctly. Other hoses may not tighten correctly
and could cause leaks. Subsequent damage to prod-
uct or property will not be covered under the terms of
the product warranty. Hoses can be ordered by calling
1-800-4-MY-HOME _.
Carefully remove the filters from the water valves
and soak them in white vinegar or a lime scale
remover, following the manufacturer's instructions. Be
careful not to damage the filters while cleaning.
Rinse before Press the filters
thoroughly reinstalling.
back into place.
O Before the flush the hoses and
reattaching hoses,
water lines by running several gallons of water into a
bucket or drain.
25