Bissell ProHeat 2X 8920 Series User Manual page 10

O
perations
Carpet cleaning continued
2. Remove formula tank from back of
machine.
3. fill the formula tank by first unscrewing
the cap and insert. always use genuine
bissell 2X formulas to maximize clean-
ing and for the safety of your machine.
fill with water to WateR line and then
fill up to foRmula line with bissell 2X
concentrated formula. Replace formula
tank.
4. set custom clean dial. simply choose
one of the 4 settings (heavy traffic,
normal clean, light clean, or water
rinse).
5. set Readytools dial to the floor cleaning
setting.
6. plug into a proper outlet and turn the power
and heater switches to the on ( i ) posi-
tion. allow 1 minute for the built-in heater
to warm-up before cleaning. the pRoheat
2X will be fully warmed and will provide
optimal performance after a minute of
continuous heated cleaning.
7. cleaning strokes. While pressing the trig-
ger, make one slow forward wet pass and
another one back. Caution: Do not
overwet. take care not to run over loose
objects or edges of area rugs. stalling
brush may result in premature belt failure.
Note: Your machine is equipped
with a circuit breaker that will
automatically shut off the brush if
a large or loose object is caught
in the brush roll. If that happens,
be sure to unplug your machine,
remove the foreign object, and
then plug the machine back in to
reset the circuit breaker.
Release the trigger and make one slow
forward and backward pass over the
same area to remove any residual
dirty water and aid in drying. Repeat
cleaning passes until solution being
pulled up appears clean. continue
passes without pressing the trigger until
you can't see any more water being
pulled up.
10
w w w . b i s s e l l . c o m
2.
4.
OR
5.
6.
Power Switch
WARNING:
to reduce the risk of fire and
electric shock due to internal com-
ponent damage, use only bissell
cleaning fluids intended for use
with the deep cleaner.
3.
Heater Switch
8 0 0 . 2 3 7 . 7 6 9 1