Download Print this page

Route The Drain Hose; Secure The Drain Hose; Level The Washer - Kenmore 110.4586 Owner's Manual & Installation Instructions

Hide thumbs

Advertisement

Proper routing o fthedrain hose protects your f loors from
damage due towater l eakage. Read and follow these
instructions.
Remove d rainhose fromwasher c abinet
Gently p ull t hecorrugated drain hose from theshipping c lips.
1.
2.
Drape the power cord over the washer top.
Secure the drain hose to the laundry tub leg or standpipe with
the beaded strap provided. (See illustrations A and B.)
Laundry tub drain or standpipe
drain
Connect the drain hose form to the corrugated drain hose.
A
B
A. Snap either end of the drain hose form to the drain hose at
the point where the corrugation
begins.
B. Bend drain hose over drain hose form and snap into place.
To keep drain water from going back into the washer:
Do not straighten the drain hose, and do not force excess
drain hose into standpipe. Hose should be secure, but loose
enough to provide a gap for air.
Do not lay excess hose on the bottom of the laundry tub.
Floor drain
You may need additional parts. See Floor drain under "Tools and
Parts."
C
If the washer faucets and the drain standpipe are recessed
(see illustration C), put the hooked end of the drain hose in
the standpipe. Tightly wrap the beaded strap around the
water inlet hoses and the drain hose.
Do not force excess drain hose into the standpipe.
II%1_
_i, W4¢:]II]D I11;]
Properly leveling your washer avoids excessive noise and
vibration.
1. Check the levelness of the washer by placing a level on the
top edge of the washer, first side to side, then front to back.
2.
3.
4.
5.
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, first prop the
front with a wood block and adjust the feet as necessary;
then prop the back and adjust feet as necessary. Repeat this
step until washer is level.
Make sure that all four feet are stable and resting on the floor.
Then check that the appliance is perfectly level (use a level).
After the washer is level, use a 17 mm open-end wrench to
turn the nuts on the feet tightly against the washer cabinet.
IMPORTANT: All 4 feet must be tightened. If the nuts are not
tight against the washer cabinet, the washer may vibrate.
When you are pushing on the edges of the washing machine
top plate, the machine should not move front to back, side to
side, or diagonally.
Slide the washer to its final location.
Confirm the levelness of the washer.
10

Advertisement

loading

  Also See for Kenmore 110.4586

  Related Manuals for Kenmore 110.4586