Complete Installation - Kenmore 110.2706 Use & Care Manual

Lower right front foot until it contacts the floor. By hand, firmly
rotate foot as much as an additional 11/2turns. The other three
feet have been preset at the factory.
Check the levelness of the washer by placing a level in the
crease between the top of the washer and the cabinet, first
on the front and then on the side.
1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See "Electrical Requirements."
2. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
3. Check that you have all of your tools.
4. Keep the foam packing ring from the washer tub for future
relocation of the washer. Dispose of/recycle all packaging
materials.
5. Check that the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
Level the front.
Level the side.
5. If the washer is not level, move the washer out slightly, tip
back, prop up the front of the washer on a wood block. Adjust
the feet up or down as necessary by twisting the feet. Repeat
steps 1 through 4 until washer is level.
6. Use a 9/16"or 14 mm open-end wrench to turn the Iocknut
counterclockwise on the foot tightly against the washer
cabinet.
IMPORTANT: If the Iocknut is not tight against the washer
cabinet, the washer may vibrate.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
7. Plug into a grounded 3 prong outlet.
8. Remove any protective film or tape remaining on the washer.
9. Read "Washer Use."
10. To test and to clean your washer, measure 1/2of the detergent
manufacturer's recommended amount of High Efficiency (HE)
powdered or liquid detergent for a medium size load and pour
it into the detergent dispenser. Close the lid. Press POWER.
Select a normal cycle and press Start. Allow it to complete
one whole cycle.
11