To Test The Safety Plug; Control Panel Operation - Kenmore 407.83086 Use & Care Manual

This product is equipped with an LCDI (Leakage Current Detection and Interruption) safety
plug. If power shuts off, unplug from the electrical outlet and make sure the cord is undam-
aged. If the cord is damaged, call 1-800-469-4663 to arrange for repair.
TO TEST THE SAFETY PLUG
1. Connect the power plug to an electrical outlet.
2. The power plug has two buttons located on the top. One button is marked "TEST" and the
other is marked "RESET' Press the "TEST" button; you will hear a click as the "RESET"
burton pops out.
3. Press the "RESET" button; you will hear a click as the button engages.
4. The power supply cord is now energized and supplying electricity to the air conditioner (it
is indicated by a light on the plug head).
• Under no circumstances should the LCD! Safety Plug be used to turn the unit on or off.
• The "RESET" button must always be pushed in (engaged) for correct operation.
• The power supply cord must be replaced if it fails to reset when the "TEST" button is
pushed in.
(4) LED DISPLAY
(8) TANK FULL (5) COOL (6) DRY (7) FAN
(2) MODE (3) TEMP SELECT (I) ON/OFF
Fig. 8
1. ON/OFF - Pressthis button to turn the air conditioner on or off.
2. MODE - Press this button to select between Cooling, Dehumidifying or air circulating
modes. The corresponding indicator will light up when each mode is selected: (5) Cool,
(6) Dry, and (7) Fan.
3. TEMP SELECT- Pressthe up arrow button while in cooling mode to increase the desired
set temperature by I°F up to a maximum setting of 86°F. Pressthe down arrow button
while in cooling mode to decrease the desired set temperature by I°F down to a low of
61°F.
o
TANK FULL - During extreme heat and humidity, the backup water tank may f111 up.
When the tank full indicator is lit, the backup water tank in the unit is full. The unit will
stop operating. Drain the backup tank. The unit will not cool until the water tank is
drained.
II