Cycle Status Indicators; Active Vent; Drying System; Overfill Protection Float - Kenmore 665.16532 Use & Care Manual

Hide thumbs Also See for 665.16532:
Table of Contents

Advertisement

Available languages

Available languages

Delay Hours
Select this option to run your dishwasher at a later time or during
off-peak hours. You can add items to the load anytime during the
delay countdown. After adding items, close the door firmly until it
latches. The delay countdown will not continue if the door is not
latched.
You can delay the start of a cycle up to 12 hours.
The first time you use Delay Hours, you will see
showing a 1-hour delay.
To delay the start
1. Close the door,
2. Select a wash cycle and options.
3.
Repeatedly press
D_Y
until you see the desired hours of delay in the display.
When the delay reaches 12 hours, the delay turns off. Press
DELAY HOURS again to select a new number of delay hours.
4.
Press START.
NOTE: To cancel the delay and cycle, press CANCEL/DRAIN.
To
cancel the delay and start the cycle immediately, press START
again.
Follow the progress of your dishwasher with the Cycle Status
indicators.
D
O
Q
O
Heating Pause
Your dishwasher adds heat to the water to improve soil removal.
The HEATING PAUSE glows while the water is heated to a
temperature determined
by the cycle chosen and the soil level
sensed. When the HEATING PAUSE glows, the countdown
display pauses until the needed temperature is reached.
Sensing
Your dishwasher senses the soil level on the dishes. Soil level
determines the length of some cycles, the amount of heat added
to the wash or rinse, and the cycle needed for the load. SENSING
glows during soil sensing, and while water is being heated. Wash
action continues while sensing occurs.
Sanitized
If you select the Sani Rinse option, SANITIZED glows when the
Sani Rinse cycle is finished. If your dishwasher did not properly
sanitize your dishes, the light flashes at the end of the cycle. This
can happen if the cycle is interrupted.
The light goes off when
you open the door.
Clean
CLEAN glows when a cycle is finished. The light turns off when
you open the door or press Cancel/Drain.
The Active Vent reduces the sounds from your dishwasher. The
cover closes after the cycle starts. Filling and washing sounds are
reduced. The Active Vent opens when wash action ends and
vapor is vented into room.
NOTE: There is a slight noise when the cover closes or opens.
This is normal.
During drying, you can see steam escaping through the vent at
the upper left corner of the doon This is normal as the heat dries
your dishes.
'1,"" "C'"
IMPORTANT: The vapor is hot. Do not touch the vent
during drying.
.,.., / I:%oteol;/o!
%1obs /
The overfill protection
float (in the front right corner of the
dishwasher tub) keeps the dishwasher
from overfilling, It must be
in place for the dishwasher
to operate.
Check under the float for objects that may keep the protector
from moving up or down.
Page 17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents