Advertisement
Available languages
Available languages
Control Lock
Option
Use the Control Lock option to avoid unintended
use of the dishwasher
between
cycles. When LOCI( ON is lit, all buttons are
disabled.
The dishwasher
door can still be opened/closed
while the controls are locked.
To turn on the Lock
Press and hold CONTROL
LOCI( for 3 seconds. LOCI( ON will light up. If you press any pad while your dishwasher
is locked,
the light flashes 3 times and an audible
tone will sound.
NOTE: The dishwasher
cannot start if the control is locked.
To turn off the Lock
Press and hold CONTROL
LOCI( for 3 seconds. The light turns off.
Status Indicator
Lights
® CO_PLE,E
The status lights on top of control
will inform you if the dishwasher
is sanitized
and/or
complete.
The lights on the control
panel will turn blue while washing
or rinsing, red while
drying, and green when complete.
Selecting
Cycles and Options
1. Select the desired cycle. If you want to run the last cycle that was completed,
you can simply press START once to show
which options you used, then press START again
to start the cycle.
2. Select the desired options. Not all options are available
for every cycle. If an invalid option is selected for a given cycle,
the lights will flash.
Turning OFF/ON
the Sound
Press and hold HIGH TEMP for 3 seconds to toggle sound ON and OFF. The sound will not be deactivated
for cycle interrupt
or service required
messages.
CQ " CQI s SiJ A OS/ce
1. Open the door slightly to stop the cycle. Wait
for the spraying
action to stop before completely
opening
the door.
2.
Press CANCEL/DRAIN
button once. The Cancel/Drain
light will light up.
3. Close the door within 3 seconds. The dishwasher
starts a drain cycle (if water
remains in bottom
of dishwasher).
Let the
dishwasher
drain completely.
The Cancel/Drain
light turns off after 2 minutes.
You can interrupt a cycle and restart your dishwasher
from the beginning
using the following
procedure.
1. Open the door slightly to stop the cycle. Wait
for the spraying
action to stop, then open the door completely.
2. Check that detergent
dispenser cover is still closed. If cover is open, you will need to refill the detergent
dispenser before
restarting
your new cycle.
3.
Press Cancel/Drain
twice to reset the control.
4. Select new cycles and options.
5.
Press START/RESUME.
19
Advertisement
