Canceling A Cycle; Changing A Cycle After Dishwasher Is Started; Adding A Dish After Dishwasher Is Started - Kenmore Elite 665.7796 Use & Care Manual

Delay Hours
Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during
off-peak hours when possible. Be sure to close the door and press START/RESUME after adding items.
To delay the start
1. Select a wash cycle and options.
2. Press the delay button to choose the number of hours to be delayed.
3. Close the door and press START/RESUME. The dishwasher starts in the selected number of hours.
NOTE: Anytime the door is opened (such as, to add a dish), the START/RESUME button must be pressed again to
resume the delay countdown.
Control Lock Option
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When LOCK ON is lit, all
buttons are disabled. The dishwasher door can still be opened/closed while the controls are locked.
To turn on the Lock
Press and hold HEATED DRY for 4 seconds. LOCK ON will light up. If you press any pad while your dishwasher is
locked, the light flashes 4 times.
NOTE: The dishwasher cannot run if the control is locked.
To turn off the Lock
Press and hold HEATED DRY for 4 seconds. The light turns off.
Status Indicator Lights
A B C Front Panel Lights - The left light indicates the dishwasher is in the
wash cycle. The middle light indicates the dishwasher is in the dry cycle.
The right-hand, green Clean light indicates the cycle is complete and
ready to unload. If the Clean light is blinking, see "Troubleshooting"
section. The Start light remains on until the cycle is completed.
A. Wash cycle C. Clean light
B. Dry cycle D. Start
1. Press CANCEL/DRAIN. The Cancel/Drain light will light up.
2. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher drain completely. The light turns off after
2 minutes. The door must be closed for the dishwasher to drain.
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser
before restarting your new cycle.
3. Press CANCEL!DRAIN twice to reset the control.
4. Select new cycles and options.
5. Firmly close the door and press START/RESUME.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. Check whether the detergent dispenser cover is still closed. If it is open, the wash cycle has already started and
adding a dish is not recommended.
3. If detergent has not yet been used (detergent dispenser cover is closed), you may add a dish.
4. Firmly close the door and press START/RESUME.
18