Table of Contents
Advertisement
Care & Cleaning
To Raise theTop
for C_eaning
1,
Grasp the sides and Hftfrom the front, A Hft-up rod wHU support the top in its raised position,
OnUyHftthe top high enough to allow the support rod to rest in pUaceunder the front of the
cooktop,
2,
CUeanunderneath using a dean cUothand hot, soapy water,
3,
To Uowerthe top, Hft the top sHghtUyand Uowerthe rod, Lower the range top down into the
range frame,
A rod swings up to support
_
When bwedng the Hft-up range top, grasp the sides with fingertips onhi, Be
neath,
carefuUnot to pinch fingers, DO NOT drop or bend the range top when raising or bwering, This
couUddamage the surface,
To Remove
and Replace
Over) Door
To Remove the Oven Door:
1, Open the door to the fully opened position,
2, Pull up the lock located on both hinge supports and engage it in the hinge levers, You may have to apply a little down-
ward pressure on the door to pull the locks fully over the hooks,
3, Grab the door by the sides, pull the bottom of the door up and toward you to disengage the hinge supports, Keep pulling
the bottom of the door toward you while rotating the top of the door toward the range to completely disengage the hinge
levers,
To Replace the Oven Door:
1,
Grab the door by the sides; place the hinge supports in the hinge slots, Open the door to the fully opened position,
2,
Disengage the lock from the hinge levers on both sides,
Note: Make sure the hinge supports are fully engaged before unlocking the hinge levers,
3,
Close the oven door,
The door is heavy, After removing door, lay it flat on the floor with the inside of the door facing down,
Lock in normaJ
position
Lock engaged
for door removaJ
:</ INGE SLOT
Door removed
from the range
Removable
Externa_
Door
G_ass
Pane_
Applicable only to models with an external glass panel not held with a frame, This design allows you to clean the inside face
of the exterior door panel as well as the hidden face of the door inner glass,
To Remove the ExternaJ Door Glass Panet:
1, Remove the door as explained above and lay the door flat,
2, Using a screwdriver, remove the 5 screws fastening,
3, Grasp both sides of the glass panel and slowly pull it out of the door upper molding, Lay the glass flat,
To Rep(ace the External Door G(ass PaneJ:
1, Grasp the sides of the glass panel and carefully insert the glass into the door top moulding,
2, Replace the 5 locking screws,
3, Replace the door onto the range,
Handle the glass panel with care, When dropped on a corner, the glass panel may shatter, This can cause
several personal injury,
16
Advertisement
Table of Contents
