HP 54600B User's And Service Manual page 170

Print/Utility Allows access to the
module menus and service menus.
Probe Allows selection of 1, 10, or
100 to match a probe's division ratio
so that the vertical scaling and volt-
age measurements reflect the actual
voltage levels at the tip of the probe.
Recall Recalls a selected front-
panel setup that you saved to one of
16 memory location. Memory selec-
tion is with either a softkey or the
knob closest to the Cursors front-
panel key.
Recall Setup Recalls the front-
panel setup that was saved with a
waveform.
Run The oscilloscope acquires
data and displays the most recent
trace.
Save Saves the current front-panel
setup to one of the possible 16 mem-
ory locations. Memory selection is
with either a softkey or the knob
closest to the Cursors front-panel
key.
Setup Allows access to front-panel
setup keys.
Single (single shot) The oscillo-
scope triggers once when the trigger
conditions are met. The oscilloscope
must be rearmed before the oscillo-
scope retriggers by pressing either
the Run or Autostore front-panel
keys.
Slope/Coupling Allows access to
the trigger slope and input coupling
menus.
Slope Selects either the rising or
falling edge of the signal to trigger
the oscilloscope.
Source Allows you to select a trig-
ger source.
Stop Freezes the display.
Time Allows access to the automat-
ic time measurement keys.
Time/Div Changes the time base
in a 1-2-5 step sequence from 2 ns to
5 s.
Time Ref Lft Cntr (time refer-
ence left or center) Sets the time
reference to either one graticule in
from the left edge of the display or
to center of the display.
Glossary
Glossary–3