Kenmore Side by Side Refrigerator Use & Care Manual page 10

Digital Controls
For your convenience, your controls are preset at the factory.
When installing your refrigerator, make sure that the controls are
still preset to the "mid-settings" as shown. The digital control
panel is located at the top of the refrigerator compartment and
enables you to view the temperature control set points.
NOTE: The factory recommended set points are 0°F (-18°C) for
the freezer and 37°F (3°C) for the refrigerator.
To turn refrigerator on and view set points:
• Press and hold ON/OFF for 2 seconds.
C0m FREEER REFRI6ERAIOR COLO
COLDER COLDER
To view the Celsius temperatures:
• Press the °C SELECT touch pad. The indicator will light up.
NOTE: If the freezer temperature is below zero, the indicator light
next to the freezer display will light up.
Adjusting Digital Controls
To adjust set point temperatures:
• Press the refrigerator or freezer up or down arrow until the
desired temperature is reached.
REFRIBERATOR COLD
COLDER
NOTE: Wait at least 24 hours between adjustments and then
recheck the temperatures before other adjustments are made.
• The set point range for the freezer is -5°F to 5°F (-21°C to
-15°C) and 33°F to 41 °F (1 °C to 5°C) for the refrigerator.
CONDITION/REASON: TEMPERATURE
ADJUSTMENT:
REFRIGERATOR too cold REFRIGERATOR
Control 1° higher
REFRIGERATOR too warm REFRIGERATOR
- High use or room very warm Control 1° lower
FREEZER too cold FREEZER Control 1°
higher
FREEZER too warm/too little ice - FREEZER Control 1°
High use or heavy ice use lower
Additional Digital Control Panel Features
Additional features are located on the control panel at the top of
the refrigerator compartment.
WATER FILTER Status and Reset
NOTE: Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction may
be used on disinfected waters that may contain filterable
cysts.
The water filter display will help you know when it is time to
change your filter. To change the filter, see the "Changing the
Base Grille Filter" section.
INDICATOR: STATUS:
99 percent New filter installed
10 percent Order replacement filter
0 percent OR flow decreases Replace filter
• After replacing the water filter, press RESET and hold for 2
seconds to change the the water filter display to 99 percent.
WATER FILleR
PERCENT REMAININ6
GrocerySavor
TM
The GrocerySavor
TM
feature assists with periods of high
refrigerator use, full grocery loads, or temporarily warm room
temperatures.
• Press GrocerySavor T_to set the temperatures to
-1O°F (-23°C) for the freezer and 34°F (1°C) for the
refrigerator. The GrocerySavor Tvindicator light will remain on
for 24 hours unless manually turned off.
NOTE: The temperature display will not change. After 24
hours, the refrigerator returns to the previous temperature set
points.
Accelerated Ice Production
This feature assists with temporary periods of heavy ice use by
increasing ice production over a 24-hour period.
• Press the accelerated ice production touch pad to set the
freezer temperature to -10°F (-23°C). The refrigerator
temperature will not change. The accelerated ice setting will
remain on for 24 hours unless manually turned off.
NOTES:
• The temperature display will not change. After 24 hours, the
refrigerator returns to the previous temperature set points.
If increased ice production is desired at all times, set the
Freezer Control to a colder number. Setting the freezer to a
colder temperature may make some foods, such as ice
cream, harder.
10